
Installation of the WeR@Home™ System
WeR@Home
™
System User Guide
3. Drill the holes; insert three (3) dowels if needed, place the base over them and screw in the three (3)
screws.
4. Slide the Tag Reader back onto its mounting base.
3.10.2.3 Installing with Pre-attached Double-side Tape
1. Release the Tag Reader mounting base by lifting the tab and sliding the base in the tab’s direction as
demonstrated in Figure 101 above.
2. Clean the surface where the Tag Reader should be installed.
3. Peel the tapes’ protective covers.
4. Attach the mounting base to its designated location while applying slight pressure.
5. Slide the Tag Reader into the mounting base.
3.10.2.4 Dismounting the Tag Reader
For dismounting the Tag Reader from its designated installation site:
1. Press over the tab.
2. Slide the Tag Reader body upwards as demonstrated in Figure 103 below.
Komentáře k této Příručce