Essence We.R Uživatelský manuál stáhnout pdf (Strana 42)

Hardware Mounting

We.R System

Symptom

Solution

3. A best practice before the “Add Device” procedure,

remove any static electricity from a device battery.

Remove static electricity from a device as follows:

Motion and Camera Devices: Remove the batteries

from the device and shake the device for a few

seconds

Key Fob: Remove the battery, and then press any

button on the Key Fob

Siren: Remove the batteries and place the small

tongue on the battery cover in the slit at the bottom

right of the battery container for a few seconds

Remove Static Electricity from the Siren

Alternatively, remove the battery cover and then

return it to its original location, over the batter

compartment.

D.2 Magnet Detector (MGL)

Symptom

The magnet (detector

and LEDs) does not

work or is warm

Check the following:

1. Verify the battery is inserted correctly with the "+" and

"-" polarity observed

2. Check for any damage to the device that may have

occurred during handling (i.e. dropping the device)

3. Verify that the alignment dots on both parts of the

detector are aligned to each other during mounting

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 54 55

Žádné komentáře

Essence We.R Uživatelský manuál Strana 42